I took a couple of empty Maxwell house coffee cans, spray painted them silver and drilled a small hole in the center of the bottom of the cans. Then I took a piece of 1 x 6 pine about a foot long and screwed the two cans to the board leaving about 6 inches between the cans. Then I took off the "top" part of my shaker scoop on my 79 TA and used a piece of rope to tie the pine board with the cans to the "bottom" part of the shaker (the air cleaner housing). Up close it was an obvious fake, but driving by it looked pretty good. I fooled all my car buddies that were at the local car hangout when I drove by. They all thought I had dual quads with velocity stacks!
I wish I had taken some pictures, but didn't. Oh well.
|