[Half-Inch Stud]

"Ship it" was a good joke indeed, but not the attitude where i worked.

As said: The induced voltages, and time-varied Mag-fields under the HEI cap are substantial enough to be a full design-optimized.

I too don't see the Alternator nor Starter Mag fields getting into the design space, nor 8 plug wires jumping high energy neither.

Overall, i started a Thread for heads-up on Reluctor Voltage Polarity. The best I can summarized to date is: The 4-pin and 7- pin modules BOTH trigger on pole-piece "Make". All my reluctors turn-out to be setup to do such.

Such elf-investigated guidance appears to go against some articles which say the 4- pin Modules trigger on the voltage decline whereas the 7-8 pin modules trigger on the voltage rise. My inspection shows they all trigger on the voltage decline.

a proper reluctor ppears to show positive voltage rise upon MAKE, and negative voltage on Break, making a triangle wave first positive then negative and back to zero. Only one 0 crossing and its a doozy.