[Formulajones]

Originally Posted by Jay S

Someone on this board might know what the volume is on the head of those 428 pistons is so you would not have to cc it. I don’t have them in any of my speedpro or TRW books. Speedpro may have changed them on the later years and made the dish a bigger diameter. Seems like the later production runs had a 8.5 cc dish and 5 cc VR’s and the older pistons like yours are a 5 cc dish with just under 6 cc VR’s. Measure the dish dimensions and see which pistons you have. Then check the deck clearance.


I agree with FJ, figure the compression and pick the
cam.

Yep, that L2257 number has long been superseded. Back about a year ago I posted that number and the pictures showing what I used in a 428 build (same thing here) and several members swore up and down those were 400 pistons. They are in fact 428 pistons and that was a good TRW part number at the time. I bought mine nearly 25 years ago.

They are flat top pistons originally, with 4 valve reliefs. I can't remember what the CC of the valve reliefs were anymore. The dish you are seeing in my previous picture, I machined in there. In the OP picture someone has done the same thing, although to a lesser degree. Way back when there weren't any off the shelf forged dish pistons for 428's, pickins were slim, so we had to make our own.