If your tossing around getting the heads milled then look into a set of custom pistons with a like a 8 to 10 CC dome.
The cost of milling the heads a minimum.045” and a custom piston may just be real close to a wash, and going to a standard normal .030” overbore would help out nicely also !
What is your reasoning for going only .010” over?
__________________
Wernher Von Braun warned before his retirement from NASA back in 1972, that the next world war would be against the ETs!
And he was not talking about 1/8 or 1/4 mile ETs!
1) 1940s 100% silver 4 cup tea server set.
Two dry rotted 14 x 10 Micky Thompson slicks.
1) un-mailed in gift coupon from a 1972 box of corn flakes.
Two pairs of brown leather flip flops, never seen more then 2 mph.
Education is what your left with once you forget things!
|