Quote:
Originally Posted by 67Fbird
Typical method for measuring \-----------/
would be part sitting flat and use 2 dowels..... 0\-----------/0
with know diameters and measure over the outside then a little trig per the known angle (45)......onless you have a couple moldmaker ball-pins 
https://us.misumi-ec.com/vona2/detail/110300560910/
and a CMM.
Otherwise it's going to take you a minute to do all the set-ups accurately and then figuring per plane. |
I know how to measure the manifold using dowel pins; was just trying to save the 5 min setup time. You know, being lazy! But, I had forgotten about tooling balls. That's a great idea. Probably best to use a factory intake vs an old aftermarket one as hopefully they're machined more accurately-- but that's probably wishful thinking.