Before I would go for cheap rollers that can and do fail and dump shrapnel your motor, I would install new stamped steel factory types in a heart beat!
Just confirm that the slot is long enough for your amount of lift and then save up for Sharp’s or stainless steel rollers.
The only time I have seen factory stamped steel rockers ware badly at there nose is when used valves have been shortened and left with a course finish, or when naturally the geometry is off by a good amount.
Super stock racers use stamped ones with no issues with far more spring pressure then you will likely be running!
__________________
Wernher Von Braun warned before his retirement from NASA back in 1972, that the next world war would be against the ETs!
And he was not talking about 1/8 or 1/4 mile ETs!
1) 1940s 100% silver 4 cup tea server set.
Two dry rotted 14 x 10 Micky Thompson slicks.
1) un-mailed in gift coupon from a 1972 box of corn flakes.
Two pairs of brown leather flip flops, never seen more then 2 mph.
Education is what your left with once you forget things!
Last edited by steve25; 09-09-2021 at 05:11 PM.
|