Interesting stuff! I never knew of the single exhaust system having never seen an SD car with factory exhaust. I guess to be more accurate in what I am attempting to do. My car will have the iron D-port long branch manifolds. I just want the bends and runs under the car to look as correct as possible for an HO installation around the crossmember, around the transmission and shifter and along the driveshaft, up and over the axle in the right place and exiting the rear in the correct location at the right place and angle. Honestly have not been able to find any pics on the internet from my searches. Plenty of pics I know are completely wrong, most cars have headers in the pics. Size of the muffler bodies would be very helpful as well. I know this is asking allot, but I want it to look as good as reasonably possible.
|