Quote:
Originally Posted by tallrandyb
Hello all, I would like to follow up on this thread as I searched and it’s the only one that hit “power antenna routing”. If there is another thread could someone point me to it?
I have a correct Pontiac rear power antenna installed on my 65 GTO, but the power wiring is just running across the two “hooks” on the top of the rear seat back frame, then down the floor drivers side and appears under the carpet over by the parking brake area at the front. The antenna cable is just routed over the hump and down on the floor pan under rear pass seat area, coiled up/not connected. Likely because the antenna end is kind of chewed up with no center cable showing. The antenna works perfectly raising/lowering when connected to power.
1) looking at these pix in this thread and with my interior fully assembled with console, what is my best approach to route the antenna and power harness to the radio and (future) dash switch? Should I just bundle them together and snake under the carpet under the console or is it better to try to run a correct path. If correct, is the power wiring run separately through the wiring channel under the drivers seat, or do they stay together like it looks for these 64 pictures?
2) I plan to buy a correct NOS dash antenna switch with a new Ames bezel/handle and install when I pull the dash this summer for other things. I assume the plastic two-wire antenna power connector with black and white wires just plug straight into a correct under-dash switch wiring harness?
3) at the antenna cable radio end, is that supposed to be a male “standard” 50 ohm connector to plug into the back of the radio (AM/FM push button)? If so, do I need to just strip it back until I hit the center wire and then crimp a new connector on and should be good to go?
Thanks for any help and discussion! I’ll post pix if that helps. I have the rear seat out and am preparing to pull drivers/passenger seat(s), console, seat belts, carpet etc to get a good path to the front. I’m now also considering installing a rear speaker while doing all this and would like to route that correctly too, nothing is back there right now. I figure I should get this all done at the same time.
Fun stuff!
|
Still working to sort this out and put my interior back in. I just bought the Ames wiring protector (pic included) and ordered a rear speaker wire (backordered so I'll have to run a plain wire for now and splice later). I'm trying to figure out where to mount the wiring protector, and another question is what type screws hold it down (I'm assuming a set of small sheet-metal type screws)?
So questions are:
1) where exactly does this wiring protector mount? Under passenger side rear seat area?
2) where should you route the rear speaker wire to get it down to the protector from the trunk area? I know there are a couple of "clip" like hooks on the seatback framing, do I use one of those?
3) I'm also running power antenna wiring and cable under this protector, how should they route from the rear antenna (I assume over the wheelwell then just curve over towards the center until they reach the protector? The 64 rear antenna wiring pictures show them being held down by individual screws/brackets themselves).
4) Once all this wiring extends past the front of the protector towards the front, do I just tape it all down in a "channel" all the way to the dash? Wiring will be: antenna cable, antenna two-wire harness, rear speaker one-wire harness, and a single-wire cable for rear camera.
Thanks for any help!!