Quote:
Originally Posted by 6d7gto
What a wealth of valuable information! Thanks gto4ben as well as to all those who chimed in thus far!
I have a question. Does the end cap with the jerk fitting just pop out when you press out the ball joint from the top? If that is the case, the cap must be press fit and I would think it could be reinstalled using some JB weld unless there is considerable pressure being exerted onto the bottom where the grease enters. Even so, couldn't JB plus a couple spot welds hold it tight without having to create an end cap of your own? Just thinking out loud since I haven't taken one apart yet.
|
Not spot welds, I mean tack welds.