So after getting the Crankshaft today and doing some rudimentary measuring I think that there’s going to be plenty of room to run a 6.7 rod
piston should clear the counterweights no problem on this SGI crank
There seems to be some confusion I’m only talking about the SGI crankshaft in this thread I was not talking about Scat, Bryant, muldex, or any of the other companies those are ones I’m familiar with this one I was not also hence why I asked but now that I have the Crankshaft I have the answer yes you can definitely run a 6.7 inch rod and probably a 6.635-6.66” if needed
__________________
Build it Right Build it Once!!!
Just another Engine Builder from the Northwest lol
|