[grandville455]

Originally Posted by Darren 639

I am going to push them out. Can’t drill on that steep of angle if there is no damage I’ll drill them and reinstall. I need to learn how to hone the bushing after reinstalling. Don’t mind replacing with new but would have to look into what is required for hone job to .904. . I install new bushings on every pump, tail shaft , clutch drums and any other bushings required for automatic transmission rebuilding. but they are always a perfect fit once in a while you may have to De-burr a little tooling marks but other than that there’s no sizing after they are installed.

I had a place in southern wi drill mine out with them installed? He just used a hand drill, then honed them after with a drill also,they were perfect for my morel lifters for clearances!