Thread: Mini-Starters and Exhaust manifolds
View Single Post
  #3  
Old 03-23-2022, 07:40 AM
Half-Inch Stud's Avatar
Half-Inch Stud Half-Inch Stud is offline
Ultimate Warrior
  
Join Date: Jul 2000
Location: BlueBell, PA or AL U.S.A.
Posts: 18,890
Default
I feel that. My Delco Hi-TQ is protected by headers.

My engine harness has a "service length" to allow the starter to land on the ground with wires attached. Really a good ting.

I think your starter will jockey out just fine after the 2 bolts are out. And if so, the front support bolt (i rarely use) can be tough to access or use a long extension deal to reach from the PS zone.

Reply With QuoteReply With Quote
The Following User Says Thank You to Half-Inch Stud For This Useful Post: