I guess I could also explain it by saying the tabs are in the wrong place ... but since they are bent pieces of thick metal, and the holes are just drilled ... I figured the mistake is in the location of the holes rather than the bends in the tabs.
These mounts have a very nice (read tight) fit on the frame mounts, no room for error at all ... even the swagging they used to hold the nut on the tab which extended maybe 1/16" into the frame mount gap would prevent them from sliding over the frame mount and had to be ground off for them to drop down onto the frame. They are some seriously strong looking mounts compared to the Chinese stuff.
__________________
I'm World's Best Hyperbolist !!
|