I hate to be the guy that advises against this... but I would use the correct equipment for the task. I have used the Van Norman, Sunnen and Rottler CNC F69A style machines. I always finish them a little on the small side and finish with an align hone after the bore. If you had a scrap block lying around then maybe. One mistake and your block is not useable.
There may be some here who have done it, but my 35 plus years as a machinist doesn't have the warm and fuzzy about it. You may be headaches ahead to find a shop. You are not far from Scott Williams, find out who does his machine work.
__________________
65 GTO, Tiger Gold, Nostalgia Super Stock 421, 2-Carter AFB carbs, Stock Suspension, 3550lbs Full Exhaust-- 9.70's@135
66 GTO (Retired race car)
421 CID
Multiple NSCA/NMCA World Champion
66 GTO 389 3x2, 4 speed, 3.90 gear, Montero Red 33K original Miles
67 GTO 2dr Post, 428, Tri Power, 3.55 Gears
80 Trans Am Black SE Y84 W72 WS6
|