As I stated in the original post, trimming will not fix this issue. You would need to cut the insert vertically between the heater control opening and the right gauge opening. Then you would need to cut a vertical strip about 1/6 of an inch wide out and then attach to the bezel with a seam running from top to bottom in the insert. that is not a little trimming, that is completely re-configuring the insert to make it fit. Unless these inserts have a variance in sizing, there is no point in sending me another one as it will just be a replay of what I just went through attempting to install this insert. I am looking for another maker of these inserts that may actually fit the bezel.
|