I did some reading before installing the 1 piece oilpan gasket, followed the directions, lay down a bead of ultra black on the start of the bow. Where the cap meets the block on both sides, and a thin ultra black bead over the cap and one on top of the gasket where it meets the oil pan. But i can not for the life of me remeber if i lay the bead on the engine side of the nubs or the transmission side. I probably lay it on the transmission side, so oil can not escape out the back ( but it reaches the nubs and wicks down there)
__________________
Murphy's law - "Anything that can go wrong will go wrong".
-469 ,Butler 310+ Eheads, Hurricane intake portmatched by butler, Butler roller 230/236 @0.50 112 LSA, Johnson lifters, pypes 2 1/2" exhaust, 3.42 yukon duragrip lsd, holley sniper efi, hyperfuel efi tank +++
|