Quote:
Originally Posted by mysticmissle
i see the guide plates say isky, I would say they need to be adjusted as you suspect. Are they all showing that off centered ness or just one or two? I have seen the adjustables welded in place after set up to avoid movement and ease reassembly if they are ever taken out from under the rocker studs.
I have used speed master plates on speed masters wo issue, have not compared to edelbrock. But i have a set of each i may be able to compare tomorrow morning if it helps
|
It's probably 50/50 some worse off than others. When I set the guide plate on a flat surface plate it will rock around a bit. I am going to get some grade 8 flat washers. Also grind the high spots down on guide plate and see if any better. Im definitely welding them now, its a real PITA to get them to stay put when tightening.