I don’t like the CC 995 springs due to the flat wire damper in them.
I prefer Crower 68407 springs which are a duel coil spring like the factory ones.
Crower 87408 retainers should be used with them.
By the time you get done rebuilding the factory rods you will really not have gained much strength and spent just about the same amount of bucks as investing in new stronger rods.
Also since due to the new forged pistons you will need to rebalance the motor, then the far lighter aftermarket rods will allow the motor to rev up a good amount faster.
You should take advantage of that and the fact that the bearing and block loads will be less.
__________________
Wernher Von Braun warned before his retirement from NASA back in 1972, that the next world war would be against the ETs!
And he was not talking about 1/8 or 1/4 mile ETs!
1) 1940s 100% silver 4 cup tea server set.
Two dry rotted 14 x 10 Micky Thompson slicks.
1) un-mailed in gift coupon from a 1972 box of corn flakes.
Two pairs of brown leather flip flops, never seen more then 2 mph.
Education is what your left with once you forget things!
Last edited by steve25; 08-15-2023 at 02:47 PM.
|