[HWYSTR455]

Did you test fit the clutch disc on the input shaft? Maybe it's getting hung on the shaft. Was it difficult to mate the trans to the bell?

You mentioned 11" setup, did you hold the disc up to the plate to make sure it fit? Possible stuff got mixed up from another box.

And just to ask, the 'flat' side of the disc is towards the flywheel?

You can drill an inspection hole in the bell too, if you need to.

If there's too much pedal throw, fingers/To might be able to hit the disc.

It's rare, but possible, the TO isn't centered on the fingers, or one side of the TO is under the fingers. You can try to peek in the hole the arm passes thru and make sure it's flat on the fingers.

Can't always trust the TO part listings either.

Just throwing stuff out there...


.