After all the cooling mods & now drilling the block for other cooling mods that shouldnt be required, it still runs hot or hotter than before even when temps are in the mid 70's?? Hope you can figure that one out...
One thing I noticed in the hand written documents.. is that you claim/think shaving .010 off the heads has raised the compression from 10.75 to... 11.75, that is absolutely incorrect, might want to run the numbers on that again. .010 off the heads will only remove a couple CC's, which will raise the comp maybe a quarter of 1 point if that. The overheating issues are NOT related to .010 milled heads.
|