[ZeGermanHam]

Also, I should take a moment to update this thread. I'm still not done with this project, but I'm pretty close. The only things left to do are wet sand the paint, install the headliner, put on the remainder of the trim and badges, and that's pretty much it! I took it for its maiden voyage a week ago and it drove great! It has a very faint u-joint vibration at ~65mph, so I'll adjust the pinion angle soon which should take care of that. I only eyeballed it when I put the rear in. Otherwise, the car performed flawlessly.

However, I wanted to put out an SOS... I pulled my wheel arch trim out of the shed today to polish it up and get it ready to install. I haven't looked at it since I put it away in 2019, and I noticed that the driver side front piece is dinged up beyond repair. If anyone has an OEM driver's front wheel arch moulding for 66-67 without dings, let me know!