Quote:
Originally Posted by Bill S
I posted my lifter / cam failure two years ago. I had two lifters / lobe failures.
I did a complete teardown / clean / and rebuild with honing, new rings, bearings. Sent the heads out for refresh and new springs with pressure verified also.
I went with the HT2148 roller lifters and spider/dog bone setup. Cam, lifters, , spider kit, pushrods, dist gear about $1000.
My issue with this is if oil was the problem, how come ALL my lifters/lobes were not wiped out ? The other lobes had the taper and lifters still convex.
|
My last post night help. The iformation was from an old man that knew what he was talking about. Right down to the location, Chicago.
What cam are you using with the 2148s?