Metal work
Surprising enough, there wasn't a lot of problems under the vinyl top. The area between the rear window and trunk lid had a little surface rust that was starting to pop the vinyl. There was some rust that was cut out on the drivers quarter and trunk lid. This car was brought down to bare metal and there was absolutely no reason to have all that bondo on the car. My painter just couldn't believe the amount of bondo that was used to hide a few dents. He ended up pulling the dents and doing a skim coat of bondo. I had him fill in the hole for the rear antenna because I wont be using the rear antenna. As you can see, my painter isn't a master welder but he did a good job to ensure that everything was welded up solid.
Last edited by Va68goat; 02-19-2024 at 09:30 AM.
|