[Verdoro 68]

Yes, I’ve been running the original driveshaft. I was going to run a conversion u joint which I figured would be fine for a while. I ended up ordering a new 3.5” steel drive shaft with a new yoke from Inland Empire Driveline. 1350 on both ends.

I measured, re-measured and re-re-measured before calling them and talked through how no measured on the phone with them. I hope the bigger diameter fits with where I have the x-pipe. The stock driveshaft was pretty close.

This piece means I’ve now rebuilt or replaced the entire drivetrain which started with the engine rebuild about a year and a half ago. Funny how things snowball. I have no excuses not to make a few passes at the track now!