[mrennie]

3 day bump + updated list of what is available. Let me know by 10 PM tomorrow night if you want something brought down

New parts:

-reproduction quarter window sash channels, does not include weatherstripping (came from PY), slightly different than what Ames sells $10

-reproduction taillight set $150

-reproduction rad cap SOLD

-front fender to rad support brackets (these are improved and thicker than OEM) SOLD

-adjustable HEI vacuum advance (came off a Pertronix flamethrower, never used) $10

-reproduction gas cap $10

-reproduction vent line bracket & screw $5

-reproduction parking brake pedal pad (I don't think it is correct for 70) $5

-gas tank insulation SOLD

-reproduction seat piping set SOLD

-rad support to front bumper filler panel SOLD

-reproduction formula wheel SOLD

-trunk drop off plug $5

-outer door & quarter window felt sets (note: I bought this set just for the driver side quarter window felt as the first one I installed did not fit well on the aftermarket quarter panel that is on my car. The one from this set fit slightly worse so I did not use it.) $50

-1970 Catalina/Bonneville B-body assembly manual - Reduced to $15.

-Griffin rad cap (17 PSI) $5

-ram air vent tube & grommet (notes: tube is zinc plated where originals were bare steel. It has a defect in it where the flange that fits against the grommet was created, it is split there and would leak air. It will require welding up the split to make it usable). SOLD

-Dash knob Ames #A274LJ $3


Used parts:

-black seat back and side covers. They have some scratches and are just starting to fade in a few spots, would be great for a driver, they just were not good enough to go with a complete new interior in my car. $100

-front fender parking light lenses. LH side has no cracks, good condition SOLD; RH side has a crack in the lens but still usable SOLD

-tack strips for headliner. These were cleaned and then primed in black epoxy. This is all of the pieces except for 2 small ones at the rear of the car. $50

-piece of hood brace from a 1970 hood. If you are putting the 68-70 repro hood on your car, be aware that the bracing is not correct for 1970 and will rub against the 70 fan shroud. The fix is to cut out the section of incorrect brace and weld in the proper piece from a 70 hood, then some minor filler & priming. The back side that will not be visible has some pitting but the front will be fine once blasted and welded in place. I will attach some pics of the work required when I have time. $10

-stainless trim for door and quarter panels. I had several sets and buffed them all then used the best ones for my project. What is for sale is a pair for the rear quarter panels, and 3 top pieces + 3 bottom pieces for the door panels (so enough to do a complete car with an extra set for the door panels). They are not perfect, but very good. $50

Thanks