[jhein]

Originally Posted by Formulajones

On a bearing lead would have been the outer protective layer, after that layer you'll see high concentrations of copper which you dont have in your analysis.

Thing is I don't think they use lead anymore as the outer layer of a bearing that I'm aware of and tin is low too which I think is used as a replacement for the lead so I tend to think that's coming from somewhere else.

Being a new engine id do just as Hoosier recommended and go another 1000 miles and check again and compare.

That's what I was thinking. That if the lead was coming from a bad bearing there would be other abnormalities as well.

I don't really know anything about shear but can that depend on how the car it driven? For example if someone just puts around and the motor never sees any WOT vs someone who gives the motor WOT at least a couple times every time they drive? And if that's the case should I consider going to a 20w50?