I went back and forth for my 67 and finally did it. It looks good and I like it. One thing I wondered about was it's accuracy so i installed an Autometer on the column and they stay within a 100 rpms of each other.
Use the template!
I read somewhere that since it was not a factory install and was done at the dealer they made the hole how they could and it was not unusual to use tin snips, so, to be correct you need a jagged edge ha ha. I had mine done with a plasma at the shop and I wasn't around to watch.
Last edited by DaleO; 08-02-2024 at 02:08 PM.
|