Quote:
Originally Posted by Kenth
Wrong.
The final factory balancing, with a fully assembled block and flywheel/flexplate, was achieved by removing metal from the crank counterweights.
The flywheels and flexplates were all the same, and this for NOT causing problems when these parts needed to be replaced.
And, If you were to buy a new flywheel from Pontiac back when new ones were available you would get a 9779232, same for all 1965-75.
FWIW
|
Thank you for clearing that up. My information came from an old GM film that showed the build process of Pontiac engines at the plant. I was almost sure I was watching the final dynamic balance being performed on rotating engines and just small amounts of finish balance material being removed externally. I remember thinking that was really bizarre as that would sort of marry the flywheel to the crankshaft which would be wrong. How in the world did they drill cast iron counterweights on an assembled engine without leaving metal in the engine? Amazing!