I do have the tool and have the clip on correctly. Here is the issue. When I installed new handles and plastic washers, the plastic washers had a raised center like a hat. But, for some reason that also covers the clip. I had to actually trim an opening or slot so the clip would fit with the washer in place. My driver side I had enough push on my panel where I used an exacto knife to cut a slice down washer to pull it out. I don't see enough push on passenger side to do the same. I'm thinking I may have to drill several holes in handle around perimeter to break it off to get washer and clip off. I'm leaving the washers off when I put back on.
|