Appreciate the reply a lot ! Just been never ending and so frustrating.
Vendor said they gravity bleed and it just works.
As we know I couldn't even get fluid through it with two man bleed.
So pressed button as I was told to do for 2 man bleed.
Did button press for whole bleed process, no bubbles then take button off.
Mine leaks out the back of the valve and as the video shows my button moves out, not in like the "other post" with the 69 firebird suggests.
Vendor is like we've never had one go bad.
So I dunno , it's been 4 years of figuring it out when i wish i just started with the valve. I can't think of anything else I've done incorrectly. It's same distribution block down below.
I'm sure we'll get through it, really appreciate PY for everyone's help.
__________________
69 Gto, 390 posi gears,th400 w/jim hand converter/406 pontiac/#64 HEADS/ 10:1 compression/ 190 PSI with/ TRW 160 thou domes / hooker headers 1 7/8, PRW 1.5 rockers, 405 Crower Springs, Holley 750 vac with proform upgrade, Performer RPM on points / 284 H Single Pattern Crane
|