If you want to view it, here is the UltraDyne lobe list at Bullet....
https://www.bulletcams.com/Masters/u...nemasters.html
As already eluded to or suggested....
There are two groupings of Hydraulic Profiles. Take note of the lobe lifts.
As Stan has suggested, you need to verify which lobes are used in the cam on hand and pay attention to the distance to coil bind at net valve lift.
Presuming it has been verified that the the springs were set for a maximum .500 lift.
.
.
__________________
'70 TA / 505 cid / same engine but revised ( previous best 10.63 at 127.05 )
Old information here:
http://www.hotrod.com/articles/0712p...tiac-trans-am/
Sponsor of the world's fastest Pontiac powered Ford Fairmont (engine)
Best time 5.13 at 140 mph (1/8 mile) , true 10.5 tire, stock type suspension
https://www.youtube.com/watch?v=qDoJnIP3HgE