[R 70 Judge]

Originally Posted by gilg

Thanks for reply after repaint my original flares and cleaning properly
try to glued the welting to the flare with this products

Permatex 80050 Clear RTV Silicone Adhesive Sealant Not Working
Permatex Super Weather-strip Adhesive Yellow Not working
3M Super Weather-strip Adhesive Black Not working

the problem is after apply very thing coating and wait about 3 minutes and reapply another very thing coating and wait about 24 hours the welting came apart not really glued, in the upper tips is the worst because the welting make 45 degrees in front and almost 95 degrees rear.

But surprise i clean again the flares and welting and use regular Krazy Glue with only few drops on the tips works in less than 2 minutes

started from the upper tips and glued only from the inside part of the flare with out bended the welting and wait about 5 minutes

and after bended and use very thin line all long from the inside part of the flare and glued perfectly with no mess at all.

after few days the welting still strong glued on the flares and the tips perfectly done that is the hard part, Just my experience Thanks

I have a new set of Danko spoilers painted and ready to install on my 70 TA. Is crazy glue still the preferred method for adhering the welting to the spoilers?

Any input is appreciated!