I am getting an occasional drip or two of gas from the injectors. I had replaced the orings on the driver side injectors because the originals didn't look very good. The standard LS injector orings don't fit quite right. Close, but not quite. The lower orings are a tiny bit too little/skinny, and the upper orings are too fat and fit too tight.
FiTech directed me to use M6x4 viton orings, 14mm OD, 6mm ID, 4mm width. Got some coming in a week or two. We'll see how those fit.
Publishing part specs for seals would be super awesome. But I dared to dream...
__________________
"...ridge reamer and ring compressor? Do they have tools like that?"
Last edited by Squidward; 10-04-2025 at 06:18 AM.
|