I have been reading a lot about how to break in a new hydraulic roller motor just out of curiosity and a lot of them say to do it in ten-minute intervals of 2800 rpms varying the speed by a few hundred rpms letting it cool down in between them for a 30-minute total run time. so, I've heard about this before.
I also was seeing it said that they recommended a 10w40 over a 5w30 with a high-performance motor because of the possibility of bleeding down the lifers with the thinner oil. I see a lot of recommendations of the Driven BR30 and BR40.
__________________
My Half AN Injun.....
|