Quote:
Originally Posted by charlie66
I have been reading a lot about how to break in a new hydraulic roller motor just out of curiosity and a lot of them say to do it in ten-minute intervals of 2800 rpms varying the speed by a few hundred rpms letting it cool down in between them for a 30-minute total run time. so, I've heard about this before.
|
This sounds like a flat tappet break in process. Where did you read this?
__________________
Will Rivera
'69 Firebird, 400/461, 290 Eddy D-Ports, HR 230/236, 4l80E, 8.5 Rear, 3.55 gears
'69 LeMans Vert, XS 350, #47 heads, TH400, 10 Bolt 3.23 gears, work in progress
‘66 Lemans, 455, 310 KRE D-Ports, HR 236/245, TH400, GV OD, 12 bolt 3.73 gears - see it here:
https://youtu.be/RP_s1wJKm_Y?si=K0NZxoTyaGcj8Dcb
|