Checked progress on the bird at The House of Hotrods and things are looking better. New reproduction RAIV intake from OER had much better fitment, but one of the coolant passage sensor holes was tapped to deep and wouldn't seal. With some research we determined that the TCS sensor wasn't needed to make the engine harness work, so a nice aluminum NPT took care of the situation. All the HVAC controls work properly with an outside vacuum source, but vacuum is not getting past the canister to the switch when running off the engine. Either a bad canister or a pinched hose.
The major culprit are the front seat tracks. So we've now learned that the 1970 seat tracks are one-year only and so is the floorpan. The bottom section of 1969 tracks aren't long enough to match the holes in the floor, and the bottom section of the 1971-74 tracks are too low and the adjusters hit the floor. So they're going to take apart my originals and the new 1969 tracks and reassemble the new uppers with their bearing cages with my original lowers. I'm glad I'm not doing that one.
All should be well though to get the car into the Arlington car show on June 6th.
|