Quote:
Originally Posted by PAUL K
.010 bearings are readily available. Can your guy turn down the OD and get the proper press fit?
|
Hey Paul!
I spoke with him Friday and he was able to find a 2 inch mandrel and ordered two sets of oversized bearings today to go this route. I appreciate him (and you) for trying to save me the cost of eventually having to line bore the cam tunnel more than once if I ever go the 50mm route.
I seem to have misplaced my cam thrust bearing (maybe once I clean up my damn shop it'll turn up - or probably after I order a new set lol). I do see that the Rollmaster Red series says on the box "
Machined for Torrington roller bearing" but I can't find any information on what that part number would even be. Not sure if you would know what that part number is? Rollmasters website is archaic and little to no information is on their site for the Pontiac set with the IWIS chain.
Thanks again gents.