Quote:
Originally Posted by 72projectbird
Took it to a cars and coffee this morning. Ran very good!
I'm trying to track down the cause of the shaker flap not actuating. So far this is what I've confirmed:
Two new solenoids
New grounds in shaker scoop, confirmed continuity between all grounds
Confirmed power at switch on carb
Confirmed power coming off switch going to shaker power inlet
Confirmed power at solenoids in shaker
I cant get them to actuate with the shaker installed on the car, but I can get the flap to actuate on the bench when powered with a cordless drill battery.
Any ideas?
|
Shaker assy is not grounding due to gasket on carb probably, IF the outter ring is connected well to the cross brace with the solenoids.