No recent experience but the one I bought some years ago sucked big time. The entire lower rail (the mounting rail) is at the wrong angle. It didnt become clear until I went to install the fenders and the upper holes were not even close. To that point, I did think the radiator seemed close to the fan but wasn't sure if I was just imagining it. This is also due to the rail being wrong.
Also, some of the bolt holes for the AC condenser were in the wrong place and had to be drilled.
I also had to trim the pass. side "ear" to be able to get the pass. fender on. It was pushing it out, away from the engine. That wasnt a big deal, just a quick hit with the cutter.
Good luck!
__________________
"If you can’t fly then run, if you can’t run then walk, if you can’t walk then crawl, but whatever you do you have to keep moving forward."
|