I tested the motor I have and it seems good. Smooth and quiet in both directions.
I fabricated some mounts and am ready to do the install except I still don't have a left side motor. I purchased one on e-bay and should have it in a few days.
My mount design is much different than Bob's. I think Bob's design would have been easier to make, but I didn't have any plate steel in my scrape pile so I made them from what I had. Mine is primarily made out of angle iron and some nuts and washers that I welded together. My design involves a good bit of cutting/welding, but it seems like the brackets will be effective. Since I don't know how to wire the module, I have not run it under power, but I have tested it by turning the knob on top of the motor and it looks like it should work well.
Bob (or anyone else) I would greatly appreciate it if you could post the wiring info ASAP.
Thanks, Joel
|