Thread: Machining crankshaft .040 on rod journals
View Single Post
  #13  
Old 07-23-2021, 07:14 PM
Half-Inch Stud's Avatar
Half-Inch Stud Half-Inch Stud is offline
Ultimate Warrior
  
Join Date: Jul 2000
Location: BlueBell, PA or AL U.S.A.
Posts: 18,476
Default
Quote:
Originally Posted by Gary H View Post
You would actually have to use a rod with a BBC big end, dimension wise, to use that bearing.
My 020 BBC Rod Bearings were only avail without the Rod-Pin hole. So Imhad to make fixture and Drill each Lower. Looks good.

__________________
12.24/111.6MPH/1.76 60'/28"/3.54:1/SP-TH400/469 R96A/236-244-112LC/1050&TorkerI//3850Lbs//15MPG/89oct

Sold 2003: 12.00/112MPH/1.61 60'/26"x3.31:1/10"/469 #48/245-255-110LSA/Q-Jet-Torker/3650Lbs//18MPG 94oct
Sold 1994: 11.00/123MPH/1.50 60'/29.5"x4.10:1/10"/469 #48/245-255-110LSA/Dual600s-Wenzler/3250Lbs//94oct
Reply With QuoteReply With Quote