When adjusted the set screw is about .310" below the top of the nut. I don't think the 5/16 gaskets will get me enough clearance. If I had a lathe I would cut down all the studs about .310" and that would do it. I found some poly locks listed as short but no dimensions. I sent Paul Spotts a message from ebay asking the length of his short nuts :-). I am pretty sure the valve cover will clear the rocker arm. If I had a set of studs that were 1-5/8 long I think that would do it. I think the short poly locks and the 5/16 gaskets would do the trick.
__________________
Tim Corcoran
|