Quote:
Originally Posted by 64speed
the flywheel that I had to replace looked bluish. I have talked to a few mechanics local who while not performance shops indicated that if I had the stop adjusted too long the clutch was not fully engaging. It may be enough to drive but not enough to “speed shift” does that sound plausible.
|
As long as the air gap between the release bearing and the clutch fingers is correct the only other option would be the stop. loosen the stop and verify travel and set the stop so as it just touches the clutch pedal as the master strokes out then take it out for a drive. Not sure what you used for a stop mine is just a 3/8 bolt with a sway bar end link poly bushing over the head for some cushion nothing special at all.