I've done a handful of these Legendary Rallye cover sets so I went back through my pics and i didn't see any particular issues like you have, but all my pics are after i was done hogringing it all and smoothed things out....
As i was looking at the old pics, i did think of a couple questions that may have impacted your install...
How did you attach the seat bun to the spring assembly/frame?
Did you glue on muslin strips or attaching cloth of some kind onto it them to secure to the spring assembly like oem, or is yours just floating and using the cover listing sleeves attachments to hold it?
I always glue on cloth strips like oem, then use those to hold it to the frame.
Next question, what are you using in the covers listing sleeves to attach down? I can't recall what legendary puts in their sleeves for these covers, but i always remove those little cardboard tubes and slide in a metal rod. Yours don't seem to have any "waves" that indicate the cardboard tubes are still in there, so you probably already did that improvement...
Since you said you adjusted the listing rod locations, I've included a photo of where the spring side listing rods SHOULD be placed- Highlighted in green.
They should be located just to the outside edge of that row of springs on each side.
I typically hogring them to every other spring loop to keep them tight to the spring assembly so they don't lift when the covers are attached to them and pulled over the bolsters.
anyway, just some thoughts and pics, hoping to help you resolve the issue....
|