Quote:
Originally Posted by JC455
That's pretty clean... my only thought is, in my case, separating the 2/3 coils so the center-fill valve covers will still work.
Keep up the great work!
|
My fill hole caused issues too. The baffle extends over past the hole, so I had to keep the bolt holes away farther than you'd think at first glance. If you look closely, I offset the end bracket one coil over, so I could get the end coil close to the breather, and to keep the back coil wire from pointing right at the master cylinder. It's no surprise really, that it's challenging adding stuff that was never intended to be there. Just doing the best I can within my means...