12-09-2022, 11:43 AM
|
|
Ultimate Warrior
|
|
Join Date: Nov 2002
Location: ABQ, USA
Posts: 5,026
|
|
Quote:
Originally Posted by gtobob67
Here's a picture of an original bearing instruction sheet I have showing the correct bearing is a cylindrical roller and not a tapered roller bearing. Tapered rollers do not like endplay whereas cylindrical bearings can live with a bit.
|
No, they don't at all. That is C-clip axle ground.
Quote:
Originally Posted by Singleton
Put a .060" shim behind the bearing race in the axle tube?
|
That may be the interim solution, especially if the end play is the same and both seals are undersized.
Quote:
Originally Posted by gtobob67
I bet you have the wrong seal on there. The 71426 original Timken seal measured .490.
|
My seal measures 0.375"
Last edited by Scarebird; 12-09-2022 at 12:23 PM.
|