View Single Post
  #324  
Old 05-07-2021, 05:26 PM
SD455DJ SD455DJ is offline
Ultimate Warrior
 
Join Date: Aug 2009
Location: Grand Rapids, MI
Posts: 3,253
Default

I did get a chance to go work on the GT-37 today, so the top of the radiator support got a much needed 'scuff & shoot' with some semi-gloss black paint...a little too glossy IMHO, but it looks reasonably better. I also painted the nose support brackets in front of the radiator along with the horns, hood latch bracket & pull lever, which were all in light gray primer. Lastly cleaned up the original hood latch and left the old plating patina. The original emissions/tune-up decal was so brittle I couldn't save it, so I installed the repop which isn't quite the same quality (blurry text/out of focus looking?) smaller font lettering and the graphics are sub-par, but, it went on anyway.

We are trying to get the heater blower motor/fan to work, but haven't been successful yet. We both are not electrical guys and not sure where to start looking and testing (I did check the fuse and it was good). We also replaced the fan switch on the dash controls, the resistor block on the suitcase (former A/C car with AC Delete kit installed), the hi-blower relay, and blower motor. We didn't check the in-line 30 amp fuse in the harness near the alternator (just thought about that). If you have any ideas, we're all ears...

Dennis
Attached Thumbnails
Click image for larger version

Name:	Core Support Before.jpg
Views:	218
Size:	70.2 KB
ID:	566087   Click image for larger version

Name:	Core Support After.jpg
Views:	248
Size:	57.3 KB
ID:	566088   Click image for larger version

Name:	20210118_163943.jpg
Views:	234
Size:	53.8 KB
ID:	566089   Click image for larger version

Name:	20210507_142739.jpg
Views:	265
Size:	47.2 KB
ID:	566090   Click image for larger version

Name:	20210507_144633.jpg
Views:	246
Size:	68.6 KB
ID:	566091  



Last edited by SD455DJ; 05-07-2021 at 05:43 PM. Reason: accidentally hit submit