Tom, can you post a picture of these plates, I would like to see how the rockers hold them in place?
Thanks in advance!
Also I can not see as posted in #16 here why he can't go up to a 3/8" custom hardened push rod with the correct ends to get things back to good again once the holes are drilled and ovaled out for the needed clearance.
There's over a .060" difference between the stock push Rods and 3/8" push Rods, and I don't see his heads being worn out that far!
__________________
I do stuff for reasons.
Last edited by 25stevem; 05-24-2022 at 06:17 AM.
|