Hi Tom very excited !! Also appreciate he hard work you have put into this. unfortunately I only have a set of wide port Edelbrock cylinder heads. Also the bolt holes are in different locations for offset wide port. Any chance intake could be ported to match ? Maybe close enough?? If not how bad would it be if it was little smaller than opening on cylinder head intake port? Back in the day I remember somebody in the racing area are used to run oval port intake on a square port cylinder head for a big block Chevy. he said he made “more low end this way”.was that even a actual possibility? Do you or anyone who is interested know best cylinder head to look for that would make the best power and work with the late intake. I appreciate any feedback sorry if my questions are stupid I am just an amateur. Darren
|