There is a few more issues with these POS. patch panels.
The holes for the clips to hold valance bolts are off. Too far to drivers side. Out 1/2 a hole.
The hole for the plastic wire protector for headlight wires is too big. Need to rework.
The top is not spot welded in the right place. Off about 1/2 inch to Drivers side. Found this out when aligning front fenders.
Sometimes is just as much work to repair your old one if not too far gone or spend hours on these.
I guess if its just a driver or race car you could just bolt it on but you won't like the alignment if your at the least bit fussy.
Good thing they are fairly cheap!
|